EN - 3
INT
ODUCTIO
N
EN
To Avoid the Hazards of Electrical Shock and Fire
• Do not handle the Power cord with wet hands.
• Do not pull on the Power cord when disconnecting it
from an AC outlet. Grasp it by the plug.
• Do not put your fingers or objects into the unit.
Location and Handling
• Do not install the unit in direct sunlight, near strong
magnetic fields, or in a place subject to dust or strong
vibration.
• Avoid a place with drastic temperature changes.
• Install the unit in a horizontal and stable position. Do not
place anything directly on top or bottom of the unit.
Depending on your external devices, noise or disturbance
of the picture and / or sound may be generated if the unit
is placed too Close to them. In this case, please ensure
enough space between the external devices and the unit.
• Depending on the environment, the temperature of this
unit may increase slightly. This is not a malfunction.
• Be sure to unplug the AC Power cord from the AC outlet
before removing the unit.
Dew Condensation Warning
• Dew condensation may form inside the unit in the
following conditions. If so, do not use this unit at least for
a few hours until its inside gets dry.
–
The unit is moved from a cold place to a warm place.
–
Under conditions of high humidity.
–
After heating a cold room.
Notice for Progressive Scan Output
• Consumers should note that not all high definition
television sets are fully compatible with this product and
may cause artifacts to be Displayed in the picture. In case
of picture problems with 480 progressive scan output,
it is recommended that the user Switch the Connection
to the ‘standard definition’ output. If there are questions
regarding your TV set compatibility with this 480p DVD
Recorder, please contact our customer service center.
FCC WARNING
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly
approved in the Manual. The user could lose the authority
to operate this equipment if an unauthorized change or
modification is made.
This transmitter must not be co-located or operated in
conjunction with any other Antenna or transmitter.
RADIO-TV INTERFERENCE
This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the Instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving Antenna.
2. Increase the separation between the equipment and
Receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the Receiver is connected.
4. Consult the dealer or an experienced radio / TV technician
for help.
Disconnect the Mains (AC) plug to shut Off when
trouble is found or not in use. The Mains (AC) plug
shall remain readily operable.
CAUTION:
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
WARNING:
Batteries (Battery pack or battery installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
IMPORTANT COPYRIGHT INFORMATION
Unauthorized copying, Broadcasting, public performance
and lending of discs are prohibited. This item incorporates
copy protection technology that is protected by U.S. patents
and other intellectual property rights of Rovi Corporation.
Reverse engineering and disassembly are prohibited.
Do not place the unit on the furniture that is capable of
being tilted by a child and an adult leaning, pulling, standing or
climbing on it. A falling unit can cause serious injury or even
death.
This apparatus should not be placed in a built-in installation
such as a bookcase or rack unless proper ventilation is
provided. Make sure to leave a space of 3.9 inches (10cm) or
more around this apparatus.
Never use a gas duster on this unit. The gas trapped inside of
this unit may cause ignition and explosion.
For MDR868H and MDR867H, do Not Connect your PC
directly to the LAN terminal of the unit.
LASER SAFETY
This apparatus is classified as a CLASS 1
LASER PRODUCT.
This apparatus employs a laser. Only a
qualified service person should remove the cover or
attempt
to service this apparatus, due to possible eye injury.
CAUTION:
Use of controls or adjustments or per-
formance of procedures other than those
specified herein may result in hazardous
radiation exposure.
p
CAN ICES-3 (B)/NMB-3(B)
( )
( )
For MDR868H and MDR867H, this device complies with
Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device.
For MDR868H and MDR867H, this transmitter must not
be co-located or operated in conjunction with any other
Antenna or transmitter.
Continued on next page.
EN.indd 3
2015/09/02 19:00:18
