MAGNATECH Pipemaster 515, Инструкция по эксплуатации и техническому обслуживанию, Страница: 46 / 101

42
10.10 Weld Notes
Use Cursor to select item, Encoder to modify.
Note: Certain items have been previously selected and cannot be changed (i.e., Weld No., Date, O.D.,
etc.). The cursor will bypass these items.
Note: To add description under Project and Drawing, see Section 9.0 on Alphanumeric Labeling
10.11 Programs Notes
Use Cursor to select line for additional notes. Save if all program selections completed (or Back
to make corrections).
10.12 How to Observe Programmed Oscillation Width (Without Striking an Arc)
In Test Mode. If a program has already been written, running the program in Test Mode will
cause the oscillator to move the torch at the programmed width as it cycles through the
program.
In Run Ready Mode. For an existing program, cycle the program to a level in which
oscillation is being used and has a programmed value. Press the Oscillation Width "+" key
one time. This will cause the oscillator to weave at the programmed value. To terminate
oscillation, press the "+" key a second time, which will center the Torch.
Caution : If you attempt to do the above in a level where there is no oscillation being used
(i.e., the root pass), when you hit the Oscillator Width "+" key, nothing will happen. However,
the system will be attempting to oscillate with a 0 value. If you attempt to do anything else at
this point, it will appear as if the system has "locked up". Be sure to press the "+" key a
second time to exit/terminate this oscillation width observation mode.
In All Other Modes of Operation. The Oscillation Width "+" key cannot be used in most other
modes of operation (for example, when writing a program) as it will increase the