Remote Control Touch / blue PiraT Re-
mote
User Guide
Datum:14.12.2018
Seite 25 von 82
RCTouch_UserGuide_V3.4.1.doc
5.6 Resetting the network settings
Note:
Due to a wrong network setting it may be impossible to reach the data logger any more.
In this case the network configuration can be resetted by a long press on the [ON / Trig-
ger] button to default settings: => Automatic DHCP configuration for TSL
with
IP
192.168.0.233
Switch off the device
Press the home button.
Active-LED and State-LED are blinking once. Active-LED is blinking green.
Press and hold the home button for about 20 sec. until the state LED is blinking 2 times.
State-LED is blinking 2 times
Active-LED is lightning green.
The network setings will be set back to default
Tipp on
[Accept]
.
The warning popup disappears.
Active-LED is blinking green.
The display shows the launcher with a progress bar.
A warning popup is shown.
Tipp on
[Accept]
.
The warning popup disappears.
The Remote Control Touch / blue PiraT Remote is ready when:
The view
[Driver view]
is shown on the display and
Active-LED is lightning green.
Afterwards the data logger can be reached again by using a direct connection with a PC/Laptop.
You’ll find more information in the
Telemotive System Client
manual