Magmaweld megaMIG, Руководство пользователя

Страница: 22 / 132

22
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
megaMIG
EN
a
b
c
BOARD
3.6 Placing the Wire Spool and Wire Feeding Process
• Unscrew the wire holder system screw. Insert the welding wire reel to the wire transport system shaft and
re-screw the screw.
• Pull down on the thrust bearing arm on the wire feed reel, which means setting thrust bearing free.
• Hold the wire tightly and pass it through the wire inlet to the reels and over the rollers into the torch.
• Remove the welding wire from the wire basket, hold the wire tightly and cut the end with
diagonal pliers.
Figure 10 : Placing Wire Basket
If the wire slips from your hands, the wire may hurt you or other people in the vicinity.
Tightening the wire transport system screw too tightly may
prevent the wire from feeding and cause malfunctions.
Tightening the screw too loose may cause the wire basket to
move freely and wire to get kinked when the wire feed is stopped.
Therefore, tighten the screw neither too tight nor too loose.
Figure 11 : Feeding Wire to Reel
• Push thrust bearings and lift thrust bearing arm .
• Turn the on/off switch to “1” position to turn on the machine .
• Press the trigger until the wire comes out of the torch tip, meanwhile observe that the welding wire reel turns
smoothly press and release the trigger several times to check if the winding is not loose .
• If the wire is loose and/or rewinding is observed, tighten the wire holder system screw slightly.
• When the wire comes out of the torch tip, reattach the nozzle and contact tip to the torch .
• Adjust wire thrust adjustment by sliding the wire onto a board and cut the wire end .
Operation