Magmaweld megaMIG, Руководство пользователя

Страница: 23 / 132

23
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
megaMIG
EN
A:
Proper wire thrust and channel size
B:
The thrust bearing arm is tightened too tightly; the shape of the wire is distorted.
C:
The thrust bearing arm is tightened too tightly; the surface of the reel is distorted.
D:
The channel length of the reel is too short for the wire used. The shape of the wire is distorted.
E:
The channel length of the reel is too long for the wire used. The wire cannot be driven to the welding area.
Figure 12 : Thrust Adjustment and Reel Selection Faults
Perform the gas adjustment and gas test by lowering the thrust bearing arm of the wire
feed reel!
3.7 Setting Gas Flow
• Adjust the gas flow with the flow control valve.
• Practical gas flow rate (CO₂, Ar, mixture) is 10
times the wire diameter.
For example, if the wire diameter is 1.0 mm, the
gas flow rate can be adjusted as
1.0 x 10 = 10 lt./min.
• You can use the table on the side for more precise
flow adjustment.
• After adjusting the gas flow, lift the thrust bearing
arm and close the wire feed unit door.
Note: Recommended values in standard conditions.
8 lt/min 8 lt/min 8 lt/min 7 lt/min
12 lt/min
10 lt/min
12 lt/min
10 lt/min
12 lt/min
10 lt/min
0.8
Mild Steel
and
Metal Cored
Flux Cored
Stainless
Steel
Aluminium
1.2
1.0
11 lt/min
9 lt/min
Diamet
er
(mm)
Operation