ID 250TW DC PULSE / ID 300TW DC PULSE
EN
www.magmaweld.com
18
USER MANUAL | KULLANIM KILAVUZU
3.2 TIG Cycle
3.3 Menu Structure
The statuses of the functions on or off according to the modes are as follows.
Pre-Gas Flow Time
0-10 sn
0-5 sn
18
Base Current
1-100
40 A
22
Final Current
1-100
30 A
26
Up-Slope Time
0.1-10 sn
1 sn
20
Frequency
0.1-2000 Hz
75 Hz
24
Spot Welding Time
0-20 sn
2 sn
28
Start Current
1-100
30 A
19
Pulse Cycle Rate
1-99
50
23
Post-Gas Flow Time
0-20 sn
0.1 sn
27
Main Current
5-250 A : ID 250 TW DC Pulse
5-300 A : ID 300 TW DC Pulse
85 A
21
Down-Slope Time
0.1-10 sn
1 sn
25
Water Cooler Time
1-20
3 dak
Parameter
Range
MMA Welding
Factory Setting
2 Stroke TIG
DC
DC
PULSE
PULSE
4 Stroke TIG
LED
3.3.1 TIG Welding Process
• 10 jobs programs including complete parameter settings can be stored and run for repeated jobs.
• In the first use, all parameters of all programs are in factory settings which are shown in the table.
• Push the program selection button. For selecting a previously adjusted program or changing its parameters.
• Push the welding mode selection button for selecting Touch-Lift TIG of HF start TIG.
• Push the 2 Stroke - 4 Stroke - Spot Welding Selection Button for selecting the appropriate mode for the work.
• Push the flat DC TIG - PULSE DC TIG selection button, for selecting flat DC TIG or PULSE DC TIG.
Latest adjusted parameter values will be saved automatically. There is no need to do anything else for saving the settings.
In HF Start TIG mode, a high ignition voltage is present at the torch. Never touch the tungsten electrode or parts condu-
cting welding current when the device is switched on.
Operation
