ID 250TW DC PULSE / ID 300TW DC PULSE
EN
www.magmaweld.com
10
USER MANUAL | KULLANIM KILAVUZU
Technical Information
TECHNICAL INFORMATION
1.1 General Information
Figure 1: ID 300 TW DC Pulse
1-
Line Cable Inlet
9-
Hot Water Input (Red)
2-
Power Switch
10-
Water Tank
3-
Remote Connection Input (Ops.)
11-
Earth Cable and Welding Cable Socket (+)
4-
Gas Input
12-
Earth Cable and Welding Cable Socket (-)
5-
Gas Output
13-
Control Panel
6-
Torch Control Connections
14-
Parameter Adjustment Knob
7-
Pedal Control Connections
15-
Torch Strap
8-
Cold Water Output (Blue)
1.2 Machine Components
ID 250 TW and 300 TW DC PULSE is an inverter type portable, mono-phase Pulsed DC TIG-MMA welding machine designed for TIG welding of all kinds
of thin metal sheets except aluminum & for MMA welding of all kinds of stick electrodes up to 5 mm.
Enhanced professional TIG controls such as, HF start, Touch-Lift, Pre-Gas, Up-Slope, Pulse, Down-Slope, Post-Gas & Crater filling are present.
Up to 10 complete jobs can be stored in the memory and run when it is necessary.
Current, time and program settings can easily be monitored by digital displays.
ID 250 TW and 300 TW DC PULSE proved well that it can work between 160 to 240 V 50-60 Hz line voltages.
Therefore this machine is quite immune to mains voltage fluctuations and perfectly welds with generator-sets.
ID 250 TW and 300 TW DC PULSE can also be used with long welding cables up to 25 mt.
The machine is fan cooled and thermally protected against over heating.
