Installation
MultiView™ II DVI-Rx-1K
Installation and User Guide
13
5.7.3 4
th
Pair Termination Settings (LED4)
The MVII-DVI-Rx-1K receiver provides settings for 4
th
pair
termination:
ON
or
OFF
. This setting has an effect
only for “-S”, “-A” and S/PDIF operating modes.
Note:
It is not possible to access the 4
th
-pair setting if an option board is installed
– since this setting is ignored.
Set to
ON
for all
single-receiver
applications, and for the
last receiver
in a daisy-chained
configuration.
This is the factory-default.
Set to
OFF
only for
mid-span
receivers in a daisy-chain configuration.
Perform the following procedure while the receiver is in the normal operating state (
CFG
indicator is off):
Press & hold the
CFG
button until the
CFG
indictor is
ON
. Release the
CFG
button.
o
LEDs 1-8 will show the current value for all configuration settings as bright/off.
Press and release the
SKEW/SEL
button twice.
LED indicator 4
should be illuminated (either DIM or ON); all others (indicators 1-3 and 5-8) should be off.
Press the
UP
or
DOWN
buttons to turn 4
th
-pair termination ON (bright) or OFF (dim).
To leave configuration-mode, leave the buttons untouched for 10 seconds or press the
CFG
button.
