Installation
MultiView™ II DVI-Rx-1K
Installation and User Guide
9
5.4
Adjustments
This section describes how to make the following adjustments:
Cable distance (EQ) compensation
Skew compensation
Note that the factory-default behavior of the MVII-DVI-Rx-1K
is “auto-adjust mode enabled” for the EQ and
Skew Compensation settings. To
exit auto-adjust mode
, simply attempt to make a manual adjustment to
either.
To
re-enable auto-adjust mode
, ensure you are in normal-operation mode and simply push both UP
and DOWN buttons simultaneously and hold for 2 seconds.
5.5
Cable Distance (EQ) Compensation Settings
When the MVII-DVI-Rx-1K is operating in normal mode (CFG indicator is off), it is possible to quickly adjust the
EQ. The EQ/SKEW indicators 1-8 will change accordingly to show
(in “bar-graph” form) 0 to 100% of the
available EQ adjustment range.
For best results, use the Magenta EQ/Skew test pattern image if possible. A test pattern
image and video instructions is available at
http://www.magenta-research.com/test
.
The following figure shows the test image you can use to make the EQ adjustment.
Figure 5: EQ-adjustment test image
To adjust EQ:
1. From normal-mode, press and hold the UP or DOWN button until the SKEW/RGB indicator turns on
(VIOLET). Release the UP or DOWN button.
2. Press the UP or DOWN buttons repeatedly to adjust the EQ setting, either one step at a time or hold
for auto-repeat.
3. To exit EQ-ADJUST mode, leave the buttons untouched for 10 seconds, or press the CFG button
once.
Auto-Adjust EQ should always provide you with a picture out of your receiver. However it may
be possible to get a better quality picture manually. We strongly recommend that all MVII DVI-
Rx units are EQ’d manually once the Auto-Adjust EQ has completed to ensure you get the best
picture possible. This also reduces the time taken for a picture to appear when changing
sources as the AutoEQ algorithm is disabled.
