Installation
MultiView™ II DVI-Rx-1K
Installation and User Guide
10
5.6
Skew Compensation Settings
The AkuComp-II skew module is already included inside the standard MVII-DVI-Rx-1K receiver. It is possible to
quickly adjust the RGB skew-compensation values when the receiver is operating in normal mode. The
EQ/SKEW indicators 1-
8 will change accordingly to show (in “bar-graph” form) 0 to 100% of the available
SKEW adjustment range (0 to 65nSec).
For best results, use the Magenta EQ/Skew test pattern image if possible. A test pattern
image and video instructions is available at
http://www.magenta-research.com/test
.
The following figure shows the test image you can use to make the SKEW adjustment.
Figure 6: Image Adjustment Utility Skew
To adjust skew:
1. From normal mode, press and hold the SKEW/SEL button until the SKEW/RGB indicator turns on
RED. Release the SKEW button.
2. Press the UP or DOWN button repeatedly to adjust the RED skew value.
3. Press and release the SKEW/SEL button. The SKEW/RGB indicator will turn GREEN.
4. Press the UP or DOWN button repeatedly to adjust the GREEN value.
5. Press and release the SKEW/SEL button. The SKEW/RGB indicator will turn BLUE.
6. Press the UP or DOWN button to adjust the BLUE value.
7. Pressing the SKEW/SEL button again will return you to step-2, allowing adjustment of the RED skew
again.
8. To exit SKEW-ADJUST mode, leave the buttons untouched for 10 seconds or press the CFG button.
