MAGA s.r.o., S. Kollára 86, Čerenčany 979 01, Slovak Republic.
+421 917 465 298, [email protected],www.magasro.sk
Made in Slovakia
20
6.3 BOILER OPERATION
Boiler start (operating the boiler)
1)
Connect the boiler controller to the power grid (plugging in)
2)
Check the amount of water in the heating system.
3)
Check whether the stop valves between the boiler and heating system are
open.
4)
Fill the container by specified fuel. After filling, the container need to be
closed by the lid.
5)
Turn on heating by touching an icon
Power
on electronic controller. (The
pellet mode on the main mode button must be on!)
6)
After switching on the control unit, the boiler is in automatic mode.
IMPORTANT WARNINGS
The boiler can be operated only by adult persons familiar with these operating
instructions. Leave children unattended by adults at the boiler, which is in operation
is not permitted.
If there is a danger of penetration of combustible vapors or gases into the boiler
room or at works where there is a risk of fire or explosion (gluing the floorings,
painting with combustible paints, etc.), The boiler must be off before the work out
of operation.
On the boiler and closer than the safe distance from it must not be stored articles of
combustible materials.
When removing the ash from the boiler must be at a minimum distance of 1500 mm
from the boiler flammable substances. The ash must be collected in the fireproof
container with a lid.
When operating the boiler at a lower temperature than 60 °C, the steel gets wet and
the exchanger is affected by low-temperature corrosion, which shortens the life of
the heat exchanger. Therefore, the boiler must be run at a temperature of 60 °C and
higher.
After the heating season it is necessary to thoroughly clean the boiler – exchanger,
burner and chimney.
Any interference into the boiler construction and electrical installation is strictly
prohibited!
