ZSX Ec
24
02/2022
Use the following procedure to set the saw for
angle cuts:
1.
Put the machine on a corresponding surface.
➢
The chain guide rail must be able to
move freely.
2.
Loosen the locking screw (9) for the swivel
setting.
3.
Pull and move the handle (6) for the swivel
setting to swivel the machine. To make setting
easy, there are pre-defined detent points at
the 0° and ±45°- positions.
➢
The cutting angle is shown on the angle
scale (8).
Fig. 31: Making the adjustment for angle cut
➢
Pull at the handle (6) to overcome the detent at 0° and ±45°. The automatic detent at 0° and
±45° is disabled when you pull the handle and rotate it through 90°.
4.
Tighten the locking screw (9) for the swivel setting afterward. Merely using the detent points without
tightening the locking screw is not sufficient.
✓
Adjustment for angle cut performed.
The possible maximum cutting depth for the individual cutting angles can be found in chapter 2.1 Technical
data.
