Mafell KSS40 18 M bl, Инструкция по эксплуатации и безопасности

Страница: 32 / 97

KSS40 18 M bl
32 01/2022
Malfunction Cause Remedial action
The machine switches off upon a
sudden load increase. The current required by the
machine also rises suddenly as
the load increases. This increase,
which occurs in the event of
sudden blockage or a kickback, is
measured and causes a
shutdown. Release the switching button to
switch off the machine.
Afterwards, you can switch the
machine back on and continue
working.
Try to avoid further blockage.
Saw blade jams when pushing the
machine forward. Feed rate too high Reduce feed rate
Blunt saw blade Release switch at once. Remove
the machine from the workpiece
and replace the saw blade
Tension in the workpiece Increased caution when sawing,
higher risk of kickback.
Poor machine guidance
(for example by freehand guiding) Use parallel guide fence
Uneven workpiece surface Align surface
Saw blade vibrates in the
workpiece Saw blade not adjusted correctly Retighten saw blade
Workpiece not secured Secure workpiece with clamps
Saw blade stops - motor
continues rotating Saw blade not properly secured Retighten saw blade
Burn marks at the cut surfaces
Saw blade blunt or unsuitable for
the operation
Replace saw blade
Chip ejector obstructed Wood too damp Clean chip ejector
Long cutting operation without
extraction Connect the machine to an
external extractor, such as a small
dust extractor
Lower movable guard does not
close or closes only slowly Chips and wooden fragments in
the lower movable guard Remove chips and wooden
fragments