1-16
7. INSPECTION AND MAINTENANCE
CAUTION
In this section, the devices indicated are exclusive for a Blade model but different from those of
a standard model. For devices other than those, refer to the section: “INSPECTION AND
MAINTENANCE” of the LC785M-6 operation manual.
7.1 MAINTENANCE EVERY 50 HOURS
[1] GREASING
CAUTION
• Grease every 10 hours until a new machine operated for 100 hours, that is the time when the
machine gets used to being run.
• Any unusual noise at greasing points shall require immediate greasing regardless of the
maintenance period.
Use a grease type in the following table depending on the greasing point.
No.
Greasing Point
Grease Type
1
Blade cylinder foot pin greasing
1 pt
2
Blade cylinder rod end pin greasing
1 pt
3
Blade foot pin greasing
2 pt
Lithium grease
1. Lower the Blade to contact the ground prior to stop the engine.
2. Grease, by using a grease pump, to the grease fitting with arrow.
3. Cleanly wipe off the old grease that was pushed out after
greasing.
Содержание 31460
Страница 2: ......
Страница 7: ...1 5 2 2 SAFETY LABEL LOCATIONS INSIDE THE CABIN...
Страница 20: ...1 18 8 2 DIMENSIONS...
Страница 21: ......