Maeda 31460, Руководство по эксплуатации, Страница: 14 / 22

1-12
6. TRANSPORTATION
CAUTION
In this section, the devices indicated are exclusive for a Blade model but different from those of
a standard model. For devices other than those, refer to the section: “HANDLING –
OPERATIONS” of the LC785M-6 operation manual.
6.1 HOW TO HOIST THE MACHINE
6.1.1 HOW TO THE MACHINE WITH THE BOOM LOWERED
NOTES
• Use four hoisting wire ropes of the same standard.
• Breaking force: 18.7 ton or more
•
φ
18 x 2.0 m or more
• Use four shackles of the same standard.
• Working load: 3.0 ton or more
CAUTION
When the machine is hoisted with the hook stored at the
end of the hook, the boom will raise due to the machine
weight, preventing the machine from being hoisted.
When hoisting the machine with the boom lowered, always
secure the hook and boom to the machine body using the
hooking wire rope.
1. Slew the crane superstructure so that the boom end comes to
the Blade side and the superstructure and track frame are
parallel.
2. Hang the hook over the hooking wire rope and move the boom
to take the posture shown in the figure on the right. Secure the
hook and boom to the machine body.
3. Shift the Blade control lever to “lower” direction so that the
Blade touches the ground.
4. Turn the fuel adjustment dial to “low idling”
position and
decrease the engine speed.
5. Turn the starter switch key to the “OFF” position and stop the
engine, then pull out the starter switch key.