Adjusting the Robo Knob Brackets
The knob screws on the MadStad adjustable brackets allow the windshield to
slide and tilt. These knob screws must always be tightened securely before
riding. DO NOT attempt to adjust the brackets while riding! You must come to
a complete stop before making adjustments. Also make sure that you do not set
the windshield in such a way that causes your handlebars or hand guards (if
installed) to hit the windshield when turning, or before reaching full lock.
To make adjustments, loosen the knobs 1-2 turns and set the windshield so the
top edge is at about your chin level as you look straight ahead while seated on
the bike. Set the angle at approximately 60 degrees. (Use the angle guide on the
back page of this manual as a guide.) Tighten the knobs and go for a ride to see
if you now have smooth airflow over and around your helmet. Do this on a
calm day if at all possible; windy days make it hard to judge the airflow. Don’t
ever try to adjust the mount while in motion!
WARNING: If you tilt the shield fully backward, it may make contact with the
top edge of the brackets. This could scratch the back of your shield, so please
check to make sure there is no contact.
To try a different windshield position, bring the motorcycle to a complete stop
and out of traffic. Loosen the two knob screws and tilt the windshield forward
or back 2-3 degrees or so, and/or adjust it up or down if necessary. Re-tighten
the knobs and go for another ride.
Continue experimenting with different positions at different speeds until you
find a combination of height and rake angle that eliminates buffeting and gives
a smoother ride. You may have more than one favorite position, for example
shield tilted forward on cooler days, and shield tilted back for hot days to let
more air to your body.
