Windshield Installation
Once bracket adjustment is complete, the windshield attaches to the brackets
with T-screws and rubber washers as shown below. Insert all four screws and
washers into the four windshield holes as shown at right before attempting to
attach the windshield onto the RoboBrackets. We recommend that you first
install the upper and
lower screws on one side,
then install the upper and
lower screws on the other
side. The rubber well
nuts are flexible and
shield holes are oversized
so you can nudge the
shield around to align the
T-screws with the holes
properly.
DO NOT OVERTIGHTEN THE SCREWS!
The rubber well nuts cannot be
pulled up out of the brackets so tighten only until they begin to swell up and the
shield is snug. Over tightening can damage the rubber well nuts.
