MADRIX STELLA, Руководство пользователя

Страница: 19 / 115

[Part 2] Device Configuration
//19
www.madrix.com
MADRIX STELLA User Manual
When data is received, MADRIX STELLA will automatically forward it to Ethernet
network.
The device automatically switches to input when receiving data via the DMX
ports [DMX-IN]. Since this happens automatically, there is no need and no
option to manually switch from output to input.
If both output and input are sent to the device, the device will activate the output.
Send Universe To Network - STELLA can receive 512 channels per port. This
setting defines on which universe those 512 channels are sent.
§
By default, 256 is set for DMX 1 and 255 is set for DMX 2.
§
Valid values range from 1 to 32768.
Always Send Full Frames To Network - Activates that always 512 channels will
be sent out.
§
512 channels are sent per frame even if the data that is received by STELLA
includes less than 512 channels for this port and universe.
§
STELLA automatically sends values of 0 on channels that are not used.
§
Art-Net Broadcast Mode - Sends Art-Net data to all IP addresses in the
network.
§
Art-Net Unicast Mode - Sends Art-Net data only to one recipient, e.g. your
MADRIX computer. Enter the IP address of your receiver here.
§
sACN Multicast Mode - Sends Streaming ACN data to IP address
239.255.1.0 for port 1 and to IP address 239.255.0.255 for port 2.
Special Commands Reboot - Reboot System - Restarts the device completely. [The website will
automatically be reloaded after a few seconds.]
Reset - Reset To Factory Default Settings - Restores the original settings of
the device. [Since this may change back the IP address to the original setting, the