macnil GT ALARM GT1006CB, Руководство по установке

Страница: 46 / 77

19
16 - SELF-LEARNING RADIO CONTROLS/ ELECTRONIC KEYS / SENSORS VIA
RADIO GT949
ATTENTION:
- Up to 10 remote controls or electronic keys and 30 radio sensors can be self-binded.
- If you try to bind a remote control/electronic key twice, the system emits 1 RED LED flash and 1
mid-length fault beep. If you try to bind a sensor by radio twice, the system emits 3 RED LED
flashes and 3 mid-length fault beep. When the maximum number of remote controls/electronic
keys/sensors via radio is reached, the system emits 10 GREEN LED flashes and 10 short fault
beeps.
WARNING ! Put the N.1 dip-switch of the sensors via radio in ON position.
WARNING ! The emergency release key GT969CH supplied is binded to the GT1001CB-B control unit.
After verifying the operation of the GT1001CB-B, the GT969CH key must be binded to the GT949 too.
1 - The system must be disarmed.
2 - Turn on the ignition of the vehicle, put the dip-switch 2 in ON. You should hear 1 long beep and see
the RED LED always on.
3 - Press the OFF button on the remote control or place the electronic key on the receptacle or press
the TEST button on the sensor.
4 - The successfully learning of a remote control/electronic key is signaled with a GREEN LED flashing
and a short beep. The successfully learning of a sensor is signaled with three GREEN LED flashes and
three short beeps.
5 - To exit the function, switch off the ignition of the vehicle and dip-switch 2 to OFF. The system
beeps long.
En