macnil GT ALARM GT1006CB, Руководство по установке

Страница: 47 / 77

20
17 - DELETION OF RADIO CONTROLS/ ELECTRONIC KEYS GT949
1 - The system must be disarmed.
2 - Turn on the ignition of the vehicle, put the dip-switch 2 in ON. You should hear 1 long beep and see
the RED LED always on.
3 - Place a working remote control or a working electronic key on the receptacle. Deletion is
confirmed by 10 flashes of the RED LED and 10 short beeps.
4 - To exit the function, switch off the ignition of the vehicle and switch 2 to OFF. The system beeps
long.
Note: The remote control/electronic key used for deletion remains binded.
18 - GT949 RADIO SENSOR DELETION
1 - The system must be disarmed.
2 - Open a working radio sensor and select ZONE 6. Close the sensor.
3 - Turn on the ignition of the vehicle, put the dip-switch 2 in ON. You should hear 1 long beep and see
the RED LED always on.
4 - Press the TEST button of the sensor just configured for ZONE 6, the operation cancels all other
sensors via radio and is confirmed by 10 flashes of the RED LED and 10 short beeps.
5 - Configure the sensor used for cancellation for ZONE 1.
6 - To exit the function, switch off the ignition of the vehicle and switch 2 to OFF. The system beeps
long.
Note: The radio sensor used for deletion remains binded.
19 - SELF-LEARNING GT949 AT GT1001CB-B
1 - The GT1001CB-B control panel must be disarmed.
2 – Enable the GT1001CB-B self-learning mode (vehicle‘s ignition on and main unit dip-switch 2 in
ON). The siren beeps and the RED LED flashes.
3 – Put the GT949 dip-switch 3 in ON. The siren beeps and the GREEN LED flashes (if the RED LED
flashes it means that the device is already binded).
4 - Switch to off the GT949 dip-switch 3.
5 - Disable the GT1001CB-B self-learning mode (vehicle‘s ignition off and main unit dip-switch 2 in
OFF). The siren emits a long beep.
En