macnil GT ALARM GT1006CB, Руководство по установке

Страница: 40 / 77

FUNCTION TABLE
No. Switch Function description ON OFF
1 RAPID TEST ENABLED DISABLED
2 SELF-LEARNING ELECTRONIC KEYS ENABLED DISABLED
3 AUTOMATIC ARMING ENABLED DISABLED
4 ACOUSTIC WARNING ON/OFF DISABLED ENABLED
5 SINGLE WIRE BLINKER CONTROL ENABLED DISABLED
6 YELLOW/BLACK WIRE OUTPUT CONFIGURATION
SEE YELLOW/BLACK WIRE OUTPUT
CONFIGURATION TABLE BELOW
7 YELLOW/BLACK WIRE OUTPUT CONFIGURATION
SEE YELLOW/BLACK WIRE OUTPUT
CONFIGURATION TABLE BELOW
8 UNUSED LEAVE IN THE OFF POSITION
9 VEHICLE DISCRIMINATOR PSA GROUP ENABLED DISABLED
10
AUTOCONFIGURATION CANBUS AND SELF-LEARNING
ANALOG VEHICLE SIGNALS
ENABLED DISABLED
YELLOW/BLACK WIRE OUTPUT CONFIGURATION TABLE
CONFIGURATION description SWITCH No. 6 SWITCH No. 7
PWM OUTPUT FOR GT843 SIREN OFF OFF
GT944 SIREN CODED OUTPUT OFF ON
INTERMITTENT NEGATIVE OUTPUT IN ALARM ON OFF
FIXED NEGATIVE OUTPUT IN ALARM ON ON
ATTENTION :
When the function is enabled, the control panel sends a "VIA RADIO" message which is stored by
the GT945 siren. For self-learning follow the procedure described in SIRENA GT 945.
- Function No. 1: QUICK TEST
With this function you can verify the correct installation of the system by performing a test of all the
alarm lines.
When the system is off, move the switch No. 1 to the ON position, the system beeps long (*) and the
control LED lights GREEN for about 3 seconds.
When the control LED is switched off, the control unit automatically performs the TEST CAN BUS to
confirm that the wires of the CAN BUS line are correctly connected and the CAN BUS configuration of
the vehicle set manually or automatically is correct. If the test is positive, the control LED lights
RED/GREEN for 5 seconds. If the CAN BUS line is not recognized after 5 seconds, the system beeps
and turns off the control LED.
13
En