Machine Mart KING 125, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 24

13
STORAGE
1. Drain all water from the hose and gun by holding the gun/lance vertically
with the nozzle pointing down and pulling the trigger.
2. Engage the gun safety catch and coil up the electricity supply cable and
the high pressure hose to prevent damage.
3. Store the power washer in a place where it is protected from frost and the
risk of unauthorized use.
MAINTENANCE
CLEANING THE INSIDE OF THE HEATING COIL (FIG.13)
The coil must be cleaned periodically, at intervals depending on the hardness
of the water supply being used.
1. Dilute 1 kg of de-scaler, with 10-15 litres of cold water into a container.
2. Connect the inlet hose (A) to the tap (B) of the container. See fig. 13.
3. Place the end of the high pressure hose (C) in the container.
4. Operate the power washer for about 20 minutes on cold setting.
5. After cleaning, disconnect the hose (A) from the tap (B) and connect it to
the mains water tap (E). See fig. 13.
6. Remove the end of the high pressure hose (C) from the container and
connect it to the gun (P). See fig. 13.
7. Remove the nozzle (U) from the lance (P), turn on the mains water tap (E).
Operate the power washer with the lance with no nozzle fitted until the
water flowing from the hose runs clear.
8. Replace the nozzle (U) on the lance and dispose of the water in the
container.
Fig. 13