Machine Mart KING 125, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 24

11
HOT WATER OPERATION
1. Turn on the water supply tap to supply water to the power washer.
2.
Fig. 8
Set the Hot / Cold selector switch
(I / 0/II) to (II) , to start the power
washer operating with hot water.
See Fig. 8.
• Pump will start
3.
Fig. 9
Take hold of the lance and pull
the trigger (A) as shown in Fig. 9
• Expect the gun to kick when
the trigger is pulled.
• Check that the water jet is
strong and continuous;
otherwise, remove the nozzle,
clean it and put it back in
place.
4. Wait a few moments to allow the
water to heat up.
5. Release trigger to stop water flow.
NOTE: The power washer will then automatically go into bypass mode.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PUMP.
WARNING: DO NOT ALLOW THE POWER WASHER TO OPERATE IN BYPASS
MODE FOR MORE THAN 5 MINUTES. OVERHEATING CAN CAUSE
DAMAGE TO PUMP.