![background image](http://html.mh-extra.com/html/macdon/r216/r216_unloading-and-assembly-instructions_685779097.webp)
215028
91
Revision A
Predelivery Checklist
Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are required, refer
to the appropriate page number in this manual. The completed Checklist should be retained by either the Operator or
the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw debris and could
result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to hazards and
unsafe practices.
Header Serial Number:
ü
ü
Item
Reference
Check that the header is level.
8.3 Leveling the Header, page 71
Check that skid shoes or gauge rollers are evenly set on
both sides of the header.
—
Ensure all shipping stands are removed from the header,
the cable ties are removed from the cutterbar curtain, and
the cutterbar curtain hangs properly.
•
3.1 Removing Shipping Supports, page 9
•
3.4 Removing Shipping Stands, page 14
•
4.1.8 Unpacking the Curtain, page 41
Check that side forming shields are evenly set.
4.1.1 Assembling and Installing Forming Shield, page 19
Check that baffle deflectors are set in field position and
the rear baffle is in the correct position: fully up for
headers with the Double Windrow Attachment (DWA)
option, and down for headers without the DWA option.
3.5 Installing Manual Rear Deflectors, page 17
Grease all bearings and drivelines.
6 Lubricating the Rotary Disc Header, page 45
Check main drive belt tension.
7.1.1 Inspecting Conditioner Drive Belt, page 49
Check suspended drum drive belts are tensioned.
7.3.1 Checking Suspended Drum Drive, page 54
Check feed roll drive belts are tensioned.
7.4.1 Checking Feed Roll Drive, page 55
Check conditioner roll timing gearbox lubricant.
7.5 Checking and Adding Conditioner Roll Timing
Gearbox Oil, page 56
Check drive gearbox lubricant.
7.6 Checking and Adding Oil in Header Drive Gearbox,
page 57
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check cutterbar lubricant.
7.7 Checking and Adding Lubricant in Cutterbar, page
59
Check for loose hardware. Tighten to required torque if
applicable.
8.9 Torque Specifications, page 80
Check cutterbar area carefully for loose parts and
hardware on the cutterbar.
—