214657
173
Revision A
Installing Header Driveline
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
CAUTION
To prevent injury, or damage to the driveline, hold the driveline so that it doesn
’
t fall to the floor.
1.
Lower header to ground, shut down combine, and remove key from ignition.
Figure 5.8: Header End of Driveline
2.
Pull back guard (A) to expose collar (B) at the header
(notched) end of the driveline.
NOTE:
The driveline may separate if not supported at
both ends.
3.
Pull back collar (B), and slide coupler onto splined input
shaft (C) until it locks. Release collar (B).
4.
Loosen bolt (D) and move plate (E) (if necessary) to
provide sufficient clearance for driveline guard.
Figure 5.9: Header End of Driveline
5.
Line up notch (A) in the driveline
’
s rubber bellows with
bolt (B) so the notch fits around casting (C) inside the
auger drive compartment.
Содержание PW8
