UNLOADING AND ASSEMBLY
Form 169018
30
Revision C
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust the position of the center-link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
2. Lower the center-link (F) with the REEL
DOWN switch onto the header pin (G) until it
locks into position (handle is down).
e. Raise the header fully with the HEADER UP
switch on the GSL. Stop engine, and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
f. Stop engine, and engage lift cylinder stops on
both lift cylinders.
g. Install pin (A) through each boot and foot and
secure with hairpin.
IMPORTANT
Ensure pin (A) is fully inserted and
hairpin is installed behind bracket on
boot.
h. Remove pin from storage position (H) in linkages
on both sides and insert at location (J) to engage
float springs. Secure with hairpin.
i.
Disengage lift cylinder stops.
CAUTION
Check to be sure all bystanders have cleared
the area.
j.
Start engine, and activate HEADER DOWN switch
on GSL to lower header fully. Stop engine, and
remove key.
DANGER
Stop engine, and remove key from ignition
before leaving operator's seat for any reason.
A child or even a pet could engage an idling
machine.
(continued next page)
A
F
G
HEADER DOWN
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER TILT UP
HEADER UP
H
J