HEADER OPERATION – D SERIES
Form 169304
67
Model Year - 2009
b. To increase (steepen) header angle, operate
HEADER TILT DOWN switch on GSL handle so
that cylinder (A) extends. The CDM display will
show a reading on the lower line of increasing
value between 00.0 and 10.0.
c. The header tilt switch can be deactivated to
prevent inadvertent header angle changes when
pressing the header height control switches.
1. To deactivate, press and hold PROGRAM
switch and momentarily press either
HEADER TILT UP or HEADER TILT
DOWN.
NOTE
If either of the header tilt switches are
pressed while deactivated, the lower
display line will indicate “TILT DISABLED”
for five seconds along with a tone.
2. To reactivate, repeat above procedure.
MECHANICAL CENTER LINK
a. Loosen plate nut (C).
b. To increase (steepen) angle, rotate barrel (D) to
lengthen center link.
c. To decrease (flatten) angle, rotate barrel (D) to
shorten center link.
d. Tighten plate nut (C) with a slight tap of a
hammer.
D
C