LIGHTS
Form 147398
29
Revision J
II. D50
a. Retrieve wiring harness from kit.
b. Disconnect reel lift cylinder at right side reel arm
as follows:
NOTE
The harness cannot be routed down the
reel arm without first disconnecting the lift
cylinder and routing harness around
cylinder and re-installing.
1. If header is attached to combine or windrower,
fully raise reel, engage reel safety prop, and
then lower reel onto safety prop until lift
cylinder is loose. Shutdown machine.
2. If header is not attached to combine or
windrower, lift reel fully with a forklift or
equivalent, engage reel safety prop, and then
lower reel onto safety prop until lift cylinder is
loose.
3. Remove cotter pin and clevis pin (A) that
connects RH reel lift cylinder to reel arm and
lower cylinder from reel arm.
c. Insert a fish tape or a piece of wire (B) through the
front of the arm and route it to the rear of the arm
as shown.
d. Attach the fish tape or wire to the square
connector end of the harness (C).
e. Route wiring harness (C) up inside reel support
arm to light at end of arm.
f. Remove fish tape or piece of wire.
(continued next page)
A
C
B
