ELECTRICAL
Form 147398
14
Revision J
q. Secure the new harness (D) to the existing
harness with electrical tape or plastic ties (C)
where shown.
NOTE
Do not tape 6-pin lead to existing harness.
r. Route the connector (K) and wiring harness (D)
under leg to the axle and through bracket (L).
s. Position clip (M) and connector (K) inside bracket
(L) and attach clip to bracket with two
¼ NC X 0.5 LG self-tapping screws (N).
t. Secure wiring harness to axle with holder (O) and
two 3/8 NC X 0.625 LG self-tapping screws (P).
u. Attach new harness (D) with clamp (Q) to lower
end of header leg, and at top of header leg with
clamp (R).
v. Feed excess harness through hole and into
backtube.
w. Proceed to STEP 4. INSTALL FRONT
SUSPENSION.
D
L
K
K
M
N
Q
R
D
D
C
TIP
Install and remove self-tapping screws
before attaching holder.
O
P
