ELECTRICAL
Form 147398
15
Revision J
INSTALLATION B
2008 Header with 4-Pin Flat Connector And 6-Pin
Square Connector.
a. Cut plastic tie (A) securing harnesses at LH
header leg.
b. Remove the two clamps (B) on header leg.
c. Route the connector (C) and wiring harness (D)
under leg to the axle and through bracket (E).
d. Position clip (F) and connector (C) inside bracket
(E) and attach clip to bracket with two
¼ NC X 0.5 LG self-tapping screws (G).
e. Secure wiring harness to axle with holder (H) and
two 3/8 NC X 0.625 LG self-tapping screws (J). If
necessary, loosen clamp inside leg and adjust
harness length as required.
(continued next page)
B
B
A
C
F
G
D
E
C
TIP
Install and remove self-tapping screws
before attaching holder.
H
J
