6. Velocity adjustment screw (anti clockwise to increase velocity)
7. Trigger with screw adjustments
8. LED display used to view gun status/settings
9. Membrane pad with power and programming buttons
10. Air hose
11. Venting ASA, screw your air system in here
12. Venting ASA on/off cap (used to turn the air on or off)
Quick Setup
Switching on and operating your marker
Switching your marker on and off
The on/off button is located on a membrane pad on the rear of the frame. Push the button with the power
. When done correctly, your LED will display a red light if no ball is loaded or a green light if a ball
is loaded and the marker will be set with the beam sensor system on and ready to fire. Turn your marker off
by holding the power button down until the LED goes blank.
Firing your marker
If a paintball is loaded in your marker, and the power is switched on, you may fire the marker by pulling the
trigger. If a paintball is not loaded, then you need to either load one, or read the section below on disabling
the beam sensor.
Understanding the beam sensor
Your marker is equipped with a visible light sensor to determine if a paintball is correctly loaded. This system
is used to prevent accidental ball breakage due to misloaded paintballs. The LED indicator on the back of
your grip will show you the status of the beam sensor:
Ball loaded – green (or special color for non-semi mode)
Ball not loaded – red
Sensor error – flashing orange
Disabling the beam sensor
To disable the sensor (for dry firing,) hold the scroll button on the membrane pad
until the LED starts
flashing. You can re-enable the beam sensor the same way.
Installing a preset air system
Your marker comes equipped with a high quality venting ASA (Air System Adaptor) that is designed for use
with commercially available air/nitrogen systems. To install your preset air system, unscrew the ASA cap by
approximately 3 turns do not unscrew it further, as the cap can come off completely. Once this is done,
carefully screw your air system into the ASA until it stops.
Turning the air on and off
To pressurize your marker, screw the ASA cap down until it stops. This will depress the pin on the end of
your air system and pressurize the marker provided you have sufficient air in your air system. To
