mabe MKR62GWTWB, Руководство по обслуживанию

Страница: 15 / 29

Service Engineering
- 15 -
REVERSING THE DOOR
REVERSING THE DOOR SOLID DOOR MODELS
1. Open the door approximately 130 degrees. With a putty
knife, remove the 4 plastic caps located along the left
side of the front panel and set them aside.
2.
Remove the bottom screw from each hinge
(right side) and partially insert them into
each top hinge hole on the left side.
NOTE : All 4 front panel hinge screws will
now be in the top hinge holes - 2 on the left
and 2 on the right.
3. Loosen each top hinge screw on right side. Remove the
door and place it on a protective flat surface to avoid any
damage.
4. Remove both the blind plate and the strike plate and
install them in opposite positions.
5. Mount the door on the 2 upper left side hinge
screws installed in step 2. Move the hinge screws
loosened in step 3 into the lower left side screw
holes and firmly tighten all 4 screws.
6. Install the 4 plastic caps removed in step 1 into
the 4 right side front panel holes.
NOTE : To return the door to the original setup, follow these instructions, swapping “left” and “right”.