mabe MKR62GWTWB, Руководство по обслуживанию

Страница: 26 / 29

Service Engineering
- 26 -
Lint filter is full • Clean lint filter before every load.
Improper or obstructed ducting • Check installation instructions for proper
ducting/venting.
• Make sure ducting is clean, free of kinks and
unobstructed.
• Check to see if outside wall damper operates
easily.
• Check the Installation Instructions to make
sure the dryer venting is correct.
Blown fuses or tripped circuit
breaker
• Replace fuses or reset circuit breakers. Since
most dryers use 2 fuses/breakers, make sure
both are operating.
Overloading/combining loads • Do not put more than one washer load in the
dryer at a time.
Under-loading • If you are drying only one or two items, add a
few items to ensure proper tumbling.
Clothes are
wrinkled
Over-drying
• Select a shorter drying time.
• Remove items while they still hold a slight
amount of moisture. Select a
Less Dry
or
Damp Dry
setting.
Letting items sit in dryer after
cycle ends
• Remove items when cycle ends and fold or
hang immediately.
Overloading • Separate large loads into smaller ones.
Clothes shrink Some fabrics will naturally shrink
when washed. Others can be
safely washed, but will shrink in
the dryer
• To avoid shrinkage, follow garment care
labels exactly.
• Some items may be pressed back into shape
after drying.
• If you are concerned about shrinkage in a
particular item, do not machine wash or tumble
dry it
Water seen on
inside of door and
top of lint filter
when opening
door after steam
cycle
Steam condenses on these
surfaces
• This is normal
Small areas on
clothes are damp
after steam cycle
Steam condenses on inner drum
• If using the
Steam Dewrinkle
cycle,
manually reduce the cycle time. If using the
Steam Refresh
cycle, add more garments to
the load.
Collars and
waistbands still
wet at end of cycle
The dryness monitor senses that
the body of the clothes
• Choose
Speed Dry
or
Timed Dry
to dry
damp collars and waistbands. In the future,
when drying a load with is dry collars and
waistbands, choose
More Dry
.
Slight variation in
metallic color
This is normal • Due to the metallic properties of paint used for
this unique product, slight variations of color
may occur due to viewing angles and lighting
conditions.
Small amount of
water on floor in
front of dryer
Inadequate load size for steam
cycle selected, excess steam
condenses inside cabinet and
leaks out
• If using the
Steam Dewrinkle
cycle,
manually reduce time. If using the
Steam
Refresh
cycle, add more garments to the
load.