13
Dry
This mode is used to decrease the humidity in the room. Under this
mode, you cannot select a fan speed. The fan motor operates at
LOW speed. Keep windows and doors closed for the best dehumidi-
fying effect.
Cool
Temperature setting is adjustable between 16 °C to 31 °C. You can
select a desired fan speed.
AUTO (on some models)
The fan motor remains on MED speed during AUTO mode. The unit
will select the appropriate operating mode from FAN, COOL or HEAT
(on reverse cycle models only) based upon the temperature differ-
ence between the actual and the desired room temperature. On
models not equipped with the MED speed, the fan motor operates
on HIGH speed in AUTO mode.
Sleep (on some models)
Press and hold the SWING keypad for 2 seconds or use the remote
control to activate or deactivate the SLEEP feature. When the sleep
feature is activated, the indicator light next to SLEEP will illuminate.
In the Cooling mode, the cooling temperature set point will increase
1°C per hour after the SLEEP mode is selected. Two hours later, the
set point will continue at this temperature and the fan motor will
remain on LOW speed.
Using the SLEEP mode will reduce noise, creating a comfortable
sleeping environment.
LED display
Shows the temperature setting or the Auto-Timer setting. After 10
seconds, it shows the room temperature (on some models) or the set
temperature (on some models).
Error codes (on some models)
Eo:
Indicates a malfunction of the outdoor condenser temperature
sensor.
When one of the above malfunctions occurs, turn off the unit, and
check for any obstructions. Restart the unit, if the malfunction is still
present, turn off the unit and unplug the power cord. Contact the
manufacturer or its service agents.
En:
Indicates a malfunction of the evaporator temperature sensor.
Er:
Indicates a malfunction of the indoor room temperature sensor.
TIMER OFF for cooling and fan operation
• On cool mode, press the TIMER button for 2 seconds, the TIMER
OFF light illuminates and the cool mode light flashes. This indicates
that the Auto Stop program for cooling operation is initiated.
Press the MODE button, the fan mode light flashes, it indicates
that the Auto Stop program for fan operation is initiated. Press the
UP or DOWN button to select the desired time.
• On fan mode, press the TIMER button for 2 seconds, the TIMER
OFF light illuminates and the fan mode light flashes. This indicates
the Auto Stop program for fan operation is initiated. Press the UP
or DOWN button to select the desired time.
• Press or hold the UP or DOWN button to change the Auto Stop
time by 0.5 hour increments, up to 10 hours, then at 1 hour incre-
ments up to 24 hours. The control will count down the time re-
maining until stop.
• Adjusting the timer setting to 0.0 will cancel the Auto Stop timer
program.
