45
Original
Version 1-2011
6.6
Replacing and tightening the belts of the angle transmission
1.
Perform steps 1–2 of Section
6.4.
2.
Use the adjustment screws A
(in Figure 42, 4 pcs) to lift the
transmission bed high enough
to enable you to slip the V-belts
(3 pcs A38) off the angle
transmission's belt pulley.
3.
Remove the blade chain belt
according to steps 3–4 of
Section 6.2.
4.
Remove the belt pulley bolt A in
Figure 41, and slip the belts (3
pcs, A 38) off the upper belt
pulley.
5.
Install the new belts, and re-
attach the fastening bolt A in
Figure 41.
6.
Put the blade chain belt in place
according to steps 5–8 of
Section 6.2.
7.
Tighten the V-belts to the
correct tension by lowering the
transmission bed with the
adjustment nuts A (in Figure
42).
Figure 41.
Figure 42.
Note! The V-belts are at the correct tension when they give approximately 20 mm when
the belt is pressed down at a moderate force.
