M86 Security 350, Руководство по установке

Страница: 18 / 126

P
RELIMINARY
S
ETUP
P
ROCEDURES
R
ACK
M
OUNT THE
S
ERVER
10
M86 S
ECURITY
I
NSTALLATION
G
UIDE
Install the Bezel on the 500 Series Chassis
After rack mounting a 500 series server, the bezel should be installed on the front
end of the chassis.
NOTE : This portion of the installation process requires you to unpack the bezel. The bezel
has been packaged separately from the unit to prevent damage during shipping.
A. Hold the bezel upright and facing towards you (Fig. 1).
Fig. 1 - Front of bezel
B. Note the short pair of end pins on the left side (Fig. 2), and the longer pair of
fixed pins on the inside top towards the middle (Fig. 3).
Fig. 2 - Pins on the left end Fig. 3 - Pins on the inside at the top of the bezel
C. Note the end pin holes (Fig. 5) on the inside of the U-shaped, aluminum rail
handles on both ends of the chassis rails (Fig. 4: U-shaped handles). Note also
that the holes for the longer pair of pins are located on the front of the chassis
above the third hard drive bay (Fig. 4: holes).
Fig. 4 - Front of chassis with U-shaped handles and holes above third hard drive identified
D. Insert the end pins into the holes of the left U-shaped handle (Fig. 5).
Fig. 5 - Holes in handle Fig. 6 - Release knob
E. Align the bezel with the front of the chassis, and then gently push the bezel
towards the front of the chassis, inserting the pins on the inside of the bezel
(Fig. 3) into the holes on the front of the chassis (Fig. 4: holes).
F. Press in the release knob on the right side of the bezel to retract the end pins on
that side (Fig. 6), and then release the knob to let the end pins extend into the
holes of the right U-shaped handle (Fig. 4: U-shaped handles).
holes
U-shaped handles