M7 SA-4320, Руководство пользователя

Страница: 4 / 24

Replacement of Swivel Seal
Replacement of Hose
Spring Canister Warning
2 Remove hose stopper from hose, and feed hose back through guide.
3 Wrap the pulled hose one time around the drum to increase tension or un-wrap hose
one time from drum to decrease tension.
4 Re-insert hose through guide, and install stopper onto hose end.
5 Unlatch the Drum and check tension. Pull hose from reel, and adjust stopper position
if necessary.
1 Turn off and disconnect supply line from swivel inlet.
2 Remove swivel assembly from reel axle.
3 Remove circlip from swivel, and take apart. Note: You may want to remove swivel
from reel hose end, but this in not necessary unless a new swivel is being installed.
4 Replace the seals and reassemble swivel.
5 Use Teflon type or thread sealant on swivel thread fitting, reconnect the swivel thread
fitting with axle.
6 Re-connect inlet supply line.
1 Turn off supply to reel.
2 Pull out all the old hose and lock the reel in this position. Caution: Make sure reel
drum is securely locked and cannot rotate back.
3 Remove two hose clamps from hose.
4 Carefully disconnect hose from swivel joint on side of reel, or male fitting in axle
center and remove old hose.
5 Feed new hose through guide and opening in drum, and connect to swivel. Re-install
two hose clamps, on inside and outside of drum flange. Install stopper on other end
of hose in the same position as before.
6 Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Note: Final spring adjustment is accomplished by adding or removing wraps of hose
around the drum. (Details see spring tension adjustment).
If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly
recommends the replacement of the spring canister be carried out by a professional
mechanic.
1 The manufacturer warrantees this hose reel against defects in material and craftsman-
ship, for a period of 12 months from date of purchase.
2 Hose, if supplied with reel, O-rings, plastic rollers and rubber stopper are deemed to
be normal wear items; not warranted.
3 The warranty does not cover damage caused by accident, misuse or faulty installa-
tion.
4 The reel must be installed and maintained in compliance with the instructions.
Limited Warranty
4