M7 DD-2050, Руководство пользователя

Страница: 18 / 41

17
TOOL MAINTENANCE
WARNING: Before any work on the machine
itself, remove the battery pack from the tool or
unplug the tool from the power source.
1. Inspect bolts periodically. If the bolts loosen,
tighten them immediately, or will result in
serious accident.
2. Inspect tool cords periodically. If damaged,
have repaired at your nearest Authorized
Service Center.
3. Keep the vents clean. Clean all parts of the
tool, clean dust periodically. To prevent debris
from entry.
4.
5.
All service MUST only be performed by Authorized
Service Center. ALWAYS use only
accessories that are recommended for this tool.
Cleaning. Avoid the use of plastic cracks
caused by damage to the solvent. Use clean
cloths and mild soap to remove dirt, dust, etc.
WARNING: Do not allow the water entering
the tool and the tool full immersed in the ware,
which will result in tool malfunction and electric
shock.
ENVIRONMENT PROTECTION
1. Tool, accessories and packaging should be
sorted for environment-friendly recycling.
2. Power tools and accessories at the end of
their service life still contain large amounts of
valuable raw materials and plastics which can
likewise be fed back into a recycling process.
3. Some dust created by working contains
harmful chemicals must be collected by
special garbage re- cycle site.
SERVICE
1. In case of guarantee, repair or purchase
of replacement parts, always contact the
2. It is without the scope of guarantee when the
tool was normal wear, overload or improper
use of damage.
Trouble Shooting
PROBLEM CAUSE SOLUTION
The drill does
not work
Battery is
depleted
Charge the
battery
Bit cannot be
installed
Sleeve is not
released
Release the
sleeve
Motor
overheating
Be sure
cooling vents
are free from
saw dust and
obstacles
Clean, clear
vents. Do not
cover with
hand during
operation
The short
battery pack
working time
The battery
pack is not
fully charged
Charge
the battery
during the
temperature
of 0°C-40°C
and check the
charger LED
indicator