8
1
0
2
s
e
c
i
v
r
e
S
M
2
M
©
3
1
Disabling a wireless detector
You can disable single wireless sensor from the RControl Admin portal. Go to the RControl Alarm menu,
Zones tab, and choose Zone type = Disable for that sensor.
Deleting a wireless detector
You can permanently delete single wireless sensor from the RControl Admin portal. Go to the RControl
Alarm menu, RF Zones, and select the zone for that sensor and press Delete (bottom left corner of the
window).
NOTE:
If you delete a sensor, you must pair it again to be able to use it again.
Deleting all keyfobs and wireless detectors
NOTE:
This procedure will delete
all paired keyfobs and wireless detectors
! To pair the keyfobs and
the wireless detectors again, you should repeat the pairing procedure for each keyfob and detector. If the
panel is
ARMED,
the deleting procedure will fail. The siren will beep 4 times to indicate an error.
All the other settings will not be deleted, e.g. Entry/Exit Delay time, Partition configurations etc. If you
want to change those setting you must log in the RControl Admin Portal.
Press and hold the “PAIR” button of the RF receiver 3 times for about 10 seconds, until the LED indicator
goes OFF each time. This will delete ALL the paired keyfobs and wireless detectors from the memory,
after the third long press.