MSP40 / MSP50
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-4883 P. 12 / 18
11. PROGRAMMING UNIT (MODEL: PU-2x)
The Programming Unit (model: PU-2x) helps the user to configure various parameters, execute Auto-setup, and to monitor
operation status of the actuator.
Turn SW1-8 ON to enable configuration and Auto-setup execution on PU-2x.
Monitoring can be conducted regardless of whether SW1-8 is ON or OFF.
■
DISPLAY OF PU-2x
G
ITEM No.
I
（
）
D
Response
Indication of set value
LCD display
■
HOW TO USE PU-2x
1) Turn SW1-8 ON to enable configuration or Auto-setup execution.
2) Connect the connection cable of PU-2x to the modular jack on the actuator unit.
The display of PU-2x comes on by power supplied to the actuator unit.
3) To display a target item, press [ITEM], then [N], [N] ([N] represents numerical number 0 to 9).
Alternatively, use [UP] or [DOWN] button to shift to the next item from the currently displayed item.
4) To change the setting value of the target item being displayed, press [DATA], enter a value, and press [ENTER].
Enter an integer or a value with one decimal place depending on the item.
When setting a tag, alphabetic characters can be used.
5) Confirm that ‘OK’ is displayed.
If the entered value is invalid or SW1-8 is OFF, ‘DATA-ERR’ will be displayed.
6) When configuration or Auto-setup is completed, remove the connect cable of PU-2x from the actuator unit, and turn SW1-
8 OFF.
■
RESPONSE MESSAGES
OK
:
OK
NON-ITEM : Item is not applicable
DATA-ERR : Value is invalid or out of range
■
PARAMETER ITEM LIST
Refer to “13. PARAMETER ITEMS COMMON TO MODBUS AND PU-2x” for the parameter item list.
