![background image](http://html1.mh-extra.com/html/m-system/mft-96-series/mft-96-series_instructions-for-the-use_3113275258.webp)
CONNECTION OF THE POWER SUPPLY CABLE
– Unhook the terminal board cover by inserting a screwdriver into the two hooks A
(fig. 9.1).
– Open the cable gland by unscrewing screw F (fig. 9.2), unscrew the terminal screws.
– Insert the feeder cable of the suitable section (as described in the next chapter) into
the cable gland.
– Connect the phase and earth cables to the terminal block according to the diagram
in figure 9.3.
– Pull the feeder cable and block it with cable gland.
– Close the terminal block cover (check the two hooks A are correctly hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws
fixing the cover plate behind the terminal block.
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
Fig. 9.1
A
F
Fig. 9.2
230 V
PE
N
L
Fig. 9.3
FEEDER CABLE SECTION Type “HO5RR-F”
230 V
3 x 1,5 mm
2
(*)
(*) – Connection possible with plug and outlet
258