![background image](http://html1.mh-extra.com/html/m-system/mft-96-series/mft-96-series_instructions-for-the-use_3113275249.webp)
Fig. 8.2
B
C
1/2” G conical
B
A
D
A
Fig. 8.3
NL
ES
The fitting (fig. 8.2) is made up of:
A -
Gas train terminal fitting (rh or lh)
B -
Gasket
C -
Conical connector
A)
GAS CONNECTION
Cat:
II
2L 3B/P
The gases used for the operation of
cooking appliances may be grouped by
their characteristics into two types:
✓
G25
✓
G30 / G31
NL
The fitting (fig. 8.3) is made up of:
A -
Gas train terminal fitting (rh or lh)
B -
Gasket
D -
Hose connector
for G30 / G31
B)
GAS CONNECTION
Cat:
II
2H3+
The gases used for the operation of
cooking appliances may be grouped by
their characteristics into two types:
✓
G20
✓
G30 / G31
ES
Use rigid or flexible connection pipes which
comply with applicable regulations.
If compression fittings are used, tighten
firmly using two spanners (fig. 8.5).
In particular, make sure that:
– the flexible hose does not come into con-
tact with any parts of the cooker with sur-
face temperatures in excess of 70˚C;
– the flexible hose does not exceed 75 cm
in length and does not come into contact
with sharp edges or corners;
– the hose is not under tension or twisted
and is not kinked or too tightly bent;
– the connection with rigid metal pipes
should not cause stresses to the gas
ramp.
– we advise replacing the gasket on the
slightest sign of deformation or imperfec-
tion.
– the hose can easily be inspected along its
entire length to check its condition; hoses
should replaced after a maximum of three
years.
– the cylinder cock or the supply cock
immediately ahead of the appliance is
closed whenever the cooker is not in use.
IMPORTANT:
To fix the gas pipe it is necessary to oper-
ate with 2 spanners (fig. 8.5).
After connecting to the mains, check
that the couplings are correctly sealed,
using soapy solution, but never a naked
flame.
249