Instructions for installation and use of ARGENTO
- 4 -
3.
INSTALLATION
3.1.
A
CTIONS TO BE TAKEN UPON INSTALLATION
Your supplier is the specialist who chooses to represent M-design in your area.
For your own safety and satisfaction, we advise you to entrust him with the
installation. The appliance has to be installed according to certain prescribed
rules and local regulations.
In the absence of the correct regulations in Belgium, the French regulations in
respect of installation will be (D.T.U. 24.2.2) applicable.
The device must be built on an area with adequate bearing capacity or slabs,
which can spread the weight of the device. The device must be placed so as to
meet all safety distance from combustible materials that could cause a fire.
However, if you decide to carry out the work on your own, we advise you to
do the following:
• Refer to the terms and conditions of our contract of guarantee.
• Ask your supplier for advice.
3.2.
P
OSITIONING THE FIREPLACE
Foundation under the fireplace insert must be of non-combustible material, flat
and must withstand thermal stress. Also, the walls and ceiling material, with
which the finishing fireplace insert, cannot be flammable or should be used
with suitable insulation.
The floor must be guaranteed minimum load capacity 1000 kg m
-2
in the
place of installation of the fireplace insert.
The floor in front of fireplace insert must be from non-combustible material at
least 100 cm in front of the front wall of the fireplace insert. The device must
be installed so that the front of it remained free space on a minimum ground
plan of about 1 x 1 m.
Place the appliance on a stable surface using the adjustable feet. Adjust the
height of the appliance turning the bolt
.
THE STOVE MAY NOT BE PLACED DIRECT ON THE
FLOOR TO ALLOW NATURAL CONVECTION. THE
APPERTURES FOR THE AIR SUPPLY (IN) IS SITUATED
UNDERNEATH THE APPLIANCES.
Regulating the height of the appliance:
This can be made in two ways.
A regulation by 5 cm (Pic.6) and a fine regulation by screw (Pic.7 ).
The minimal height as from ground to the 4th side frame is 8 cm (A min).
The minimal height “C min” will be 22,6 cm, measured as from the ground to 4th
side frame.
3.3.
A
IR SUPPLY FOR COMBUSTION
Every form of combustion uses air. In the case of a thermally sealed room
supplementary air supply is essential. One must at all times avoid creating
under-pressure in the room. If a cooking hood appears to be absolutely
essential in the adjoining room, sufficient air supply will have to be provided
to avoid every form of under-pressure.
You need an air supply with dia. 150mm coming from outside, or a ventilated
place (garage, basement ...). This air inlet you have to connect to the Argento.
Opening for the external air supply is located at the bottom and sides of the
fireplace Argento (Pic.9). For the air supply from side is necessary to remove
the side covers.
B
A
C
6 x 5 cm
A min = 8 cm
B = 14,6 cm
C min = 22,6cm
Pic.6
Pic.7
Pic.8
5cm
