Lynx D AA 5320 D, Справочное руководство

Страница: 24 / 33

Reference Manual D AA 5320 Version 2.0
Page 24
Set Mono Gain Level
When in mono mode the Right input channel is sent
to all 8 audio outputs. Please follow the procedure
below to set the gain in Mono mode.
1. Set Switch 1
[enable local adjustment]
to ON
2. Set Switch 2
[Stereo / Mono Select]
to OFF *
3. Set Switch 3
[Set Unity]
to OFF
4. Push DN or UP buttons to adjust gain level. Each
press changes the gain by 0.5dB, holding the
button down will change the gain in a fast
mode
5. If 10 seconds pass with no further adjustments
being made both channel status LEDS will flash
yellow four times. This confirms settings have
been written into flash ram and stored.
6. To prevent further accidental adjustment it is
recommended to set Switch 1
[enable local
adjustment]
to OFF
* When is mono mode the RIGHT channel status LED will go out.
Auto Store
If no parameters are changed for 10 seconds then
the current settings will be written into flash memory
automatically, this can be seen by the channel
condition LEDS flashing yellow four times.
Note. Diagram only
shown for switch
location reference
not actual settings
OFF
1
2
3
4
ON