Lynx D AA 5320 D, Справочное руководство

Страница: 19 / 33

Reference Manual D AA 5320 Version 2.0
Page 19
Set Stereo / Mono Mode
The D AA 5320 module can be set to one of two
preset modes of operation.
Stereo . This is a simple 2 x 1 to 4 amplifier.
Independent left and right channels passed
through the amplifier providing four balanced line
outputs for each input channel.
Mono . This is a simple 1 x 1 to 8 amplifier. The signal
on the LEFT input channel is passed through the
amplifier providing eight balanced line outputs of
this channel.
Use this procedure to select Stereo or Mono modes
of operation.
1. Set Switch 1
[enable local adjustment]
to ON
2. Set Switch 2
[stereo / mono select]
to ON for Stereo
or OFF for Mono*
3. If 10 seconds pass with no further adjustments
being made both channel status LEDS will flash
yellow four times. This confirms settings have
been written into flash ram and stored.
4. To prevent further accidental adjustment it is
recommended to set Switch 1
[enable local
adjustment]
to OFF
*
When in mono mode the RIGHT channel indicator will go out.
Note. Diagram only
shown for switch
location reference
not actual settings
OFF
1
2
3
4
ON