Lynx Adventure 800, Руководство оператора

Страница: 46 / 75

45
ENGLISH
VEHICLE WARM-UP
Before every ride, vehicle has to be warmed up as follows:
Snowmobile must be securely supported by the rear bumper using a wide-base snowmobile
mechanical stand. Track must be 100 mm off the ground.
Start engine and allow it to warm up two or three minutes at idle speed.
Release barking brake.
Make sure wide-base snowmobile mechanical stand is stable. Stay clear of the front
of vehicle and the track. Do not use too much throttle during warm-up or when track
is free-hanging.
Apply throttle until drive pulley engages. Let track rotate at low speed for several turns. The
lower the vehicle temperature is the longer vehicle warm-up should be.
Shut-off the engine and remove the wide base snowmobile mechanical stand.
Skis may be frozen on the ground. Grab both skis one at a time by their loops and lift their
front end slightly off the ground.
After restarting engine, the vehicle can be driven at low speed for the first 2 or 3 minutes of
riding. After that, it may be driven up to the legal speed limit as per normal safety practices.
POST OPERATION CARE
Shut off the engine. Install rear of vehicle on a wide-base snowmobile mechanical stand.
Remove snow and ice from rear suspension, track, front suspension, mechanism and skis.
Protect vehicle with a snowmobile cover.
Engine overheating
IMPORTANT NOTICE!
4-tec models: Engine idling more than 10 minutes after driving may cause engine
overheating.
Fan cooled models: Shut off the engine.
Check for clogged air duct passages. Remove any foreign materials.
Check for proper fan belt condition and tension.
Liquid cooled models: Engine overheating pilot lamp will light up if engine is too hot.
Reduce snowmobile speed and run snowmobile in loose snow or stop engine immediately.
Check for adequate coolant level. See an authorized Lynx dealer.
WARNING!