Lynton Luminette Q, Руководство оператора, Страница: 17 / 29

13
________________________________________________________________________________
space to operate efficiently. The user must also ensure that air can flow freely
underneath the Luminette Q System. The air inlet vents are in the base plate
of the cabinet and must not be blocked.
The Luminette Q System must first be plugged into the mains and the room
mains supply switched on if a switch is present.
Turning on the keyswitch will start up the system. The Welcome Screen will
appear on the LCD and it will be possible to hear the low hum of the internal
water pump and cooling fan. The blue illuminated pushbuttons will also
strobe, if enabled.
Lynton - Lasers - Ltd LUMINETTE Q
WELCOME
========= -
After about 2 seconds the Welcome screen will automatically change to the
Standby Screen shown below.
Lynton Lasers Ltd LUMINETTE Q
Shots -- : 130 Status - : STANDBY
Spot --- : 3mm HP ----- : 1064nm
<Shutdown> <Spot-> <Spot+> <Treat>
This is an example of the main Standby Screen, from where operating
parameters can be selected and the system can be enabled for treatment.
This Standby screen displays the handpiece type currently connected to the
Luminette Q system in the “HP” area of the screen.
As can be seen, the screen can be used to choose the treatment spot size.
The spot size is shown on screen and can be adjusted by pressing the <Spot-
> (decrease) and <Spot+> (increase) buttons. The spot sizes available will
depend on the particular Handpiece that is attached to the Luminette Q
System. Also shown is the total number of Shots that the Handpiece has
delivered so far. If this number exceeds the recommended number a Warning
will also be given on the second line of the LCD. It also shows the number of
shots that the Handpiece has done so far in
it’s lifetime.
Treatment can now be started by pressing the <Treat> button. The power
supply charger will start up (accompanied by a low hissing noise), the
simmer will strike and the screen will change to the following warning screen:
WARNING : It is important to check that the correct handpiece type is
connected before EACH treatment session. The handpiece type can be seen
onscreen when connected and on the handpiece itself