LXNAV LX80 Series, Руководство пользователя

Страница: 85 / 224

Rev # 23 Version 7.10 December 2019
There is another input called VARIO PRIORITY. When this input is activated by
grounding the appropriate wire the unit will ch ange to Vario immediately. This
input wire is set open (not grounded) as a factory default on delivery.
In case i f Becker radio, PTT line on input for “mute vario” can be only used if
there is a diode wired in the line, otherwise Becker radio stays in a transmit
mode.
5.1.11.1.4.1 SC Configuration with the NEW TYPE (from 2016) Remote Stick
The new LXNAV remote stick comes without the standard SC cable and VP cable, however
the function is still available.
With the new stick, there is no more need to solder these wires to the vario wiring loom.
The SC function is programmable through the LX80/90xx (version 5.x) .
Please make sure that none of the input s is set to
“SC on/off switch” or "SC toggle button".
Configuration table for all SC switch options for new and old sticks:
Remote stick type SET: Input (SC) setting
LX NEW remote without SC cable No t in use
Old LX remote with SC cable (before 8/2015) »SC toggle button«
Old remote stick with SC switch »SC on/off switch«
Using flap sensor Not in use
Using magnetic flap sensor (AS style) » SC on/off switch«
5.1.11.1.4.2 Conditions to Trigger a GEAR Warning
There are 3 options when the GEAR warning is triggered.
If both Inputs: GEAR and AIRBRAKES are connected to the system, the warning will be
triggered under following co nditions:
•
When altitude is below 200m
•
When Airbrakes are opened
If only AIRBRAKES input is connected the warning will be triggered when:
•
Altitude is below 100m
If no inputs are present the following conditions must meet to trigger the warning:
•
Indicated speed below 126km/h
•
AGL below the AGL setting (setup ->warnings- >gear)
•
Negative Vario
•
Flat terr ain below