LXE MX7, Справочное руководство

Страница: 35 / 60

Docking and Undocking the MX7 29
E-EQ-MX7DKRG-C MX7 Cradle Reference Guide
Docking and Undocking the MX7
Refer to previous section titled
Install / Remove Vehicle Cradle Adapter Cup and Top Adapter.
When the MX7 is in Suspend Mode it wakes up when docked in a powered cradle. There is no
change in mode state settings or behavior when the MX7 is docked in an unpowered cradle.
MX7 mode states
while the MX7 is in a powered cradle
e.g. suspend, resume, display backlight,
etc., are managed by the settings in
Start | Settings | Control Panel | Power
and
Start | Settings
| Control Panel | Display
in the MX7 Control Panel
.
The MX7 can be inserted and removed from the charging pocket with one hand.
The MX7 is inserted into the charging pocket with the keypad facing forward.
Always put the
handle through the Handle Opening first or damage to the scanner aperture may occur.
Dock the MX7 --
Carefully press the MX7 down into the charging pocket until the 20 pin
connector at the base of the MX7 clicks into place with the charging connector at the bottom of
the charging well. The Docked LED illuminates.
Push the MX7 backwards into the vehicle cradle until the Retainer snaps forward, securing the
MX7 to the vehicle cradle.
Undock the MX7 --
Remove the MX7 from the cradle by first lifting the Retainer upwards. The
MX7 charging pocket hinges forward, allowing the MX7 to be pulled up and out of the charging
pocket. The Docked LED turns off.
Figure 21 MX7 Docking and Undocking
Important: Do not dock the MX7 until the dock is secured and stable. If the cradle or MX7 is
damaged, it must be removed from service and repaired.