Luvion ICON CLEAR 70, Инструкция по эксплуатации

Страница: 7 / 30

7 LUVION
Premium Baby products
•
Use only the originally supplied adapters. Use only on standard (100 ~ 240 volts AC) power
points.
• If you travel abroad, check the voltage on your unit’s plugs match the local power output.
•
This product is not a toy. Don’t let children play with it.
•
The baby monitor is not suitable for use as a medical surveillance monitor.
•
The baby monitor is not a substitute for parental supervision.
• Do not use the baby monitor in a damp environment or near water, such as in the bath-
room, kitchen, laundry room or wet basement, etc.
•
This product is only suitable for indoor use.
• It is important to fi rst check the range and condition of the baby monitor before fi rst use
and then on a regular basis.
•
Test the connection well when the baby monitor is moved.
• Use the baby monitor at a temperature between 10 °C and 40 °C, do not place the baby
monitor in direct sunlight or at other heat sources such as radiators, candles, gas cooker, etc.
Ensure there is suffi cient ventilation space around the baby monitor.
• Never dismantle the parent or baby unit yourself, this invalidates the warranty. This must be
done by certifi ed personnel, contact the seller of the local distributor for this.
•
Only replace the batteries with original Luvion batteries of the same type. Using the wrong
batteries may damage your baby monitor.
• Make sure that the parent unit is fully charged on fi rst use. This guarantees an optimum
battery life.
•
Dispose of used batteries in accordance with local environmental regulations.
SETUP & USE
1. PARENT UNIT SETUP
1.1 Setting up
1.
Plug one of the power cables into the socket on the back of the Parent unit. (fi g. 3)
2.
Plug the other end of the cable into your mains wall socket and switch it on.
3.
Activate the batteries by pulling the plastic tab away from the back of the Parent
unit. (fi g. 5)
4.
Leave the batteries to charge for 16 hours to reach maximum charge. When they
are fully charged the battery light will show full charge.
Warning: Only use the power adapters supplied. Using incorrect power adapters may
permanently damage your product.
1.2 Battery low alert on Parent unit
When the batteries on your Parent unit are running out, an alert will sound and the
battery icon will fl ash. When this happens, you’ll need to charge the batteries.
If you ever need to remove the batteries, slide open the battery compartment cover
and use the ribbon to push them out.
Warning: Always use rechargeable batteries in the Parent unit. Only use the type we’ve
recommended – 2 x AA NiMH 1300mAh batteries. Charge the batteries as instructed in
this user guide. The Parent unit can still be used when it’s charging.
EN